Hi Anatoly, my bad - I have to admit sometime I "forget" about the documentation after writing the code.... - I will take care of this and see if the docs needs to be updated.
Regards, Bogdan Anatoly Pidruchny wrote: > Juha, > > you can also change the debug level temporarily per process for a script > section using the script function setdebug. Below is some information > from the ChangeLog for 1.3.x release. This function is still not > documented in the core cookbook. > > 2007-07-19 08:23 Bogdan-Andrei Iancu, <bogdan at voice-system dot ro> > > * [r2478] action.c, cfg.lex, cfg.y, dprint.c, dprint.h, route.c, > route_struct.c, route_struct.h: > - new core script function - setdebug([leve]) - it can be used to > change the debug level (per process) for a script section. > > -- > Anatoly. > >> Edson writes: >> >> > It would be even better if this control could be done not only through MI >> > commands, but also through script commands/variable. It would permit >> > increase and decrease debug level based on script logic given a more >> > granular control over debug info. >> >> that should be possible if debug variable would be mapped to a shared >> memory variable that could then be set using cfgutils functions. >> >> -- juha >> >> _______________________________________________ >> Devel mailing list >> Devel@lists.openser.org >> http://lists.openser.org/cgi-bin/mailman/listinfo/devel >> >> >> > > > _______________________________________________ > Devel mailing list > Devel@lists.openser.org > http://lists.openser.org/cgi-bin/mailman/listinfo/devel > > _______________________________________________ Devel mailing list Devel@lists.openser.org http://lists.openser.org/cgi-bin/mailman/listinfo/devel
