On Mon, 2010-02-01 at 10:50 -0800, Robert Love wrote: > On Mon, 2010-02-01 at 02:57 -0800, [email protected] wrote: > > HI again, > > > Hi Danilo > > > all done.... > > > > now i've recompiled a kernel for enabling DCBX and VLAN but when i try to > > load fcoe module i've got message: > > > > fcoe: Unknown symbol vlan_dev_real_dev.... > > > I'm working on a patch to update the initiator QUICKSTART, here's what I > have for the things that need to be enabled in the kernel configuration. > Check your .config against the following settings. I think your error > message indicates that you don't have a required VLAN setting turned on. > > Networking Support -> Networking Options > Data Center Bridging > 802.1Q VLAN Support > GVRP (GARP VLAN Registration Protocol) support > > Networking Support -> Networking Options -> QoS and/or fair queuing > Multi Band Priority Queueing (PRIO) > Hardware Multiqueue-aware Multi Band Queuing (MULTIQ) > Elementary classification (BASIC) > Universal 32bit comparisons w/ hashing (U32) > Extended Matches > U32 key > Actions > SKB Editing > > Device Drivers -> SCSI Device Support -> SCSI Low-level drivers > LibFC > LibFCoE > FCoE > > > i'll try to resolove the issue :). > > > > anyone has got some configuration of all cfg files? ex open-fcoe.conf , hba. > > conf and stuff like that? > > > On the initiator side open-fcoe.conf is obsolete. Are you trying to run > in point-to-point mode or are you connected to a fabric?
I just wanted to add that much of the DCB configuration settings are likely not relevant if you're in point-to-point mode. _______________________________________________ devel mailing list [email protected] http://www.open-fcoe.org/mailman/listinfo/devel
