On 08/22/2012 09:37 AM, Subodh Nijsure wrote:
>
> For a MX28 based hardware I am working with I need to use AUART4
>
> I need to configure this AUART4 as uart only when necessary and at all
> other times pins associated with AUART4 need to be configured as inputs.
Out of curiosity, why?
BTW, you didn't CC any of the IMX maintainers, so it's likely they won't
see your question. I've CC'd LinusW, Shawn, and Dong.
> I am using following DT definitions to setup AUART4 mux but can't
> figure out how to setup pin direction via DT, can it be done or I need
> to do it in C code?
>
> apb@80000000 {
> apbh@80000000 {
> auart4_pins_a: auart4@0 {
> reg = <0>;
> fsl,pinmux-ids = <
> 0x3142 /*
> MX28_PAD_SAIF0_MCLK__AUART4_CTS */
> 0x3152 /*
> MX28_PAD_SAIF0_LRCLK__AUART4_RTS */
> 0x3162 /*
> MX28_PAD_SAIF0_BITCLK__AUART4_RX */
> 0x3172 /*
> MX28_PAD_SAIF0_SDATA0__AUART4_TX */
> >;
> fsl,drive-strength = <0>;
> fsl,voltage = <1>;
> fsl,pull-up = <0>;
> };
> auart4_highz_pins: auart4-gpio@0 {
> reg = <0>;
> fsl,pinmux-ids = <
> 0x3143 /*
> MX28_PAD_SAIF0_MCLK__GPIO_3_20 */
> 0x3153 /*
> MX28_PAD_SAIF0_LRCLK__GPIO_3_21 */
> 0x3163 /*
> MX28_PAD_SAIF0_BITCLK__GPIO_3_22 */
> 0x3173 /*
> MX28_PAD_SAIF0_SDATA0__GPIO_3_23 */
> >;
> fsl,drive-strength = <0>;
> fsl,voltage = <1>;
> fsl,pull-up = <0>;
> };
> };
> };
I don't know IMX HW, but where is highz controlled? On other SoCs I'm
familiar with, when a pad is configured as a GPIO, the highz state is
controlled by the GPIO module, so there's nothing pinmux can do about
it. Even if the pinmux HW does control highz, gpio_direction_*() are
still meant to communicate with the pinctrl driver to implement this, so
overriding it through the pinctrl configuration seems like a bad thing.
So I think your UART driver would have to request the GPIOs, and set
them as inputs. So, I guess your UART node below would need a property
listing the GPIOs to do this to.
> apbx@80040000 {
> auart4: serial@80072000 {
> pinctrl-names = "default", "auart";
> pinctrl-0 = <&auart4_highz_pins>;
> pinctrl-1 = <&auart4_pins_a>;
> status = "okay";
> };
> };
_______________________________________________
devicetree-discuss mailing list
[email protected]
https://lists.ozlabs.org/listinfo/devicetree-discuss
