On Sun, Nov 11, 2012 at 05:12:58PM -0800, Anton Vorontsov wrote: > On Mon, Nov 12, 2012 at 02:00:31AM +0100, Linus Walleij wrote: > > On Sun, Nov 11, 2012 at 5:21 PM, Andrew Lunn <[email protected]> wrote: > > > > > From: Jamie Lentin <[email protected]> > > > > > > Given appropriate devicetree bindings, this driver registers a > > > pm_power_off function to set a GPIO line high/low to power down > > > your board. > > > > > > Signed-off-by: Jamie Lentin <[email protected]> > > > Signed-off-by: Andrew Lunn <[email protected]> > > > > So this is just a GPIO client like any such thing right? > > > > I mean this thing has nothing more to do with the GPIO subsystem > > than say, drivers/input/keyboard/gpio_keys.c? > > > > So from the GPIO subsystem point of view controlling power is > > an alien concept. > > > > But I suspect Anton may be ready to welcome a driver like this > > under drivers/power/* which I think is where it belongs. > > Yup. driver/power/reset/ seems appropriate.
Hi Anton I was unsure where to put it. I will submit new patches with the move. I'm not too sure about 'reset' though. Its not a reset operation, the power goes off and stays off. Would 'shutdown' or 'power_off' be better? Andrew _______________________________________________ devicetree-discuss mailing list [email protected] https://lists.ozlabs.org/listinfo/devicetree-discuss
