The binding documentation for the OMAP GPIO controller has the description for the "#interrupt-cells" property after the "interrupt-controller" definition. This is confusing so is better to move "interrupt-controller" after the "#interrupt-cells" description.
Reported-by: Stephen Warren <[email protected]> Signed-off-by: Javier Martinez Canillas <[email protected]> --- .../devicetree/bindings/gpio/gpio-omap.txt | 2 +- 1 files changed, 1 insertions(+), 1 deletions(-) diff --git a/Documentation/devicetree/bindings/gpio/gpio-omap.txt b/Documentation/devicetree/bindings/gpio/gpio-omap.txt index bff51a2..8b9914c 100644 --- a/Documentation/devicetree/bindings/gpio/gpio-omap.txt +++ b/Documentation/devicetree/bindings/gpio/gpio-omap.txt @@ -10,7 +10,6 @@ Required properties: - second cell is used to specify optional parameters (unused) - gpio-controller : Marks the device node as a GPIO controller. - #interrupt-cells : Should be 2. -- interrupt-controller: Mark the device node as an interrupt controller The first cell is the GPIO number. The second cell is used to specify flags: bits[3:0] trigger type and level flags: @@ -18,6 +17,7 @@ Required properties: 2 = high-to-low edge triggered. 4 = active high level-sensitive. 8 = active low level-sensitive. +- interrupt-controller: Mark the device node as an interrupt controller. OMAP specific properties: - ti,hwmods: Name of the hwmod associated to the GPIO: -- 1.7.7.6 _______________________________________________ devicetree-discuss mailing list [email protected] https://lists.ozlabs.org/listinfo/devicetree-discuss
