On Thu, Mar 26, 2015 at 05:38:23PM +0000, Ben Dooks wrote:
> The mmc1 channel is not populated on the SAM5D3 Xplained board, however
> it is enabled and therefore the driver is attaching to it.
> 
> The node configuration for mmc1 is missing, so add an mmc1 node in the
> device tree so add the basic node, set it to default it to disabled. Also
> add the vmmc and also the necessary slot configuration if this node
> where to be enabled to avoid the following warnings from the driver.
> 
> atmel_mci f8000000.mmc: No vmmc regulator found
> atmel_mci f8000000.mmc: No vqmmc regulator found
> 
> Signed-off-by: Ben Dooks <[email protected]>

Acked-by: Ludovic Desroches <[email protected]>

> --
> CC: [email protected]
> CC: Andrew Victor <[email protected]>
> CC: Nicolas Ferre <[email protected]>
> CC: Jean-Christophe Plagniol-Villard <[email protected]>
> CC: Rob Herring <[email protected]>
> CC: Pawel Moll <[email protected]>
> CC: Mark Rutland <[email protected]>
> CC: Ian Campbell <[email protected]>
> CC: Kumar Gala <[email protected]>
> CC: Russell King <[email protected]>
> CC: [email protected]
> CC: [email protected]
> ---
>  arch/arm/boot/dts/at91-sama5d3_xplained.dts | 11 +++++++++++
>  1 file changed, 11 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/at91-sama5d3_xplained.dts 
> b/arch/arm/boot/dts/at91-sama5d3_xplained.dts
> index fec1fca..652c4dd 100644
> --- a/arch/arm/boot/dts/at91-sama5d3_xplained.dts
> +++ b/arch/arm/boot/dts/at91-sama5d3_xplained.dts
> @@ -43,6 +43,17 @@
>                               };
>                       };
>  
> +                     mmc1: mmc@f8000000 {
> +                             vmmc-supply = <&vcc_3v3_reg>;
> +                             vqmmc-supply = <&vcc_3v3_reg>;
> +                             status = "disabled";
> +                             slot@0 {
> +                                     reg = <0>;
> +                                     bus-width = <4>;
> +                                     cd-gpios = <&pioE 1 GPIO_ACTIVE_LOW>;
> +                             };
> +                     };
> +
>                       spi0: spi@f0004000 {
>                               cs-gpios = <&pioD 13 0>, <0>, <0>, <&pioD 16 0>;
>                               status = "okay";
> -- 
> 2.1.4
> 
> 
> _______________________________________________
> linux-arm-kernel mailing list
> [email protected]
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to