Has anyone been able to configure this to work with dynamic DNS sites? It appears to map the name to the IP address once and save that rather than the host name you configure with.
Also, I was unable to configure port monitoring on an SME system? It gave me a screen without any location to enter port information. And finally, it doesn't seem to be able to detect that the monitored system is Linux - at least not for me. Anyone else seen any of these issues (or better yet - been able to overcome them)? Regards, Bruce Friedman -----Original Message----- From: Darrell May [mailto:[EMAIL PROTECTED]] Sent: Friday, March 29, 2002 4:13 PM To: Allen Rapini Cc: e-smith-devinfo Subject: [e-smith-devinfo] RE:[e-smith-devinfo] npulse network monitor HowTo available Allen Rapini <[EMAIL PROTECTED]> said: > I had to go to /usr/lib/perl5/5.6.0/CPAN and rename the file Config.pm > to Config.pm.old... I found the same, but noticed I simply had to hit enter to continue so I did not bother at first to think this was an issue. I've now added your notes into the Howto. Thanks for the feedback and fix report Allen. Regards, -- Darrell May DMC Netsourced.com http://netsourced.com http://myEZserver.com -- Please report bugs to [EMAIL PROTECTED] Please mail [EMAIL PROTECTED] (only) to discuss security issues Support for registered customers and partners to [EMAIL PROTECTED] To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Archives by mail and http://www.mail-archive.com/devinfo%40lists.e-smith.org
