Recap on my set-up.. WinXP -> Rigblaster Pro -> FT-7800R -> A Handi Talkie..
All of the pieces above, except for the handi talkie, are brand new last week. The PC is 2.8Ghz P4, 512M. The mike jumpers are wired per the sheet of paper included with the special cable. I'm using as a test platform the most current version of EchoLink. If I run echolink in single user mode, with the classic mike in and headphones, the audio round trip is fine. If I run the software in single user mode, I put headphones in the headphone jack on the PC and I select "Line" In as the recording source and when connected to the echotest server the radio audio routes through the Rigblaster unit and is echoed back very clear. If I switch it to SysOp mode, remove the headphones, the system messages relating to connect and disconnect messages get transmitted via the FT-7800R and are very clear. sent through the mike in of the radio are fine.. I was able to use this config to listen to the shuttle audio this afternoon. So far so good.. Here is the part I can't figure out.. I dropped the connection to the conference server that was echoing the shuttle audio and brought up the echotest server. When I transmit, the audio isn't even recognizable.. It is low and distorted.. So at the point I can use the audio from the FT-7800R in single user mode fine. I can listen to a listen only conference server. But I can't use it as a real RF Link.. I would love any pointers that come to mind.. 73's K1DWU P.S. The "No Audio" problem went away when I unplugged the computer speakers. --- In [email protected], "Jim Clark" <[EMAIL PROTECTED]> wrote: > I am using a Rig Blaster with my Yaesu FT100 and it works fine. > > The first thing I would check is to make sure that there is output from the sound card. This can easily be checked by plugging a speaker into the sound card at the same location you are plugging the audio cable going to the Rig Blaster. If you can't get audio in the speaker then the sound card audio out needs set up. Go to the audio controls for the sound card and make sure you have the Wav and audio out turned up. Also make sure these are not muted. If your computer has more than one sound card make sure the correct one is selected in the software you are running. > > Jim > > ----- Original Message ----- > From: jtwoodstock > To: [email protected] > Sent: Saturday, July 30, 2005 11:43 PM > Subject: [digitalradio] Rigblaster & Yaesu FT7800R > > > Anyone get these two to work together? > > I bought the special cable, wired the jumpers the way that it said on > the paper included with the cable.. > > The PTT seems to work, but no audio.. > > Any thoughts? > > > > > > The K3UK DIGITAL MODES SPOTTING CLUSTER AT telnet://208.15.25.196/ > More info at http:///www.obriensweb.com > > > > > SPONSORED LINKS Craft hobby Hobby and craft supply Ham radio > > > ------------------------------------------------------------------------------ > YAHOO! GROUPS LINKS > > a.. Visit your group "digitalradio" on the web. > > b.. To unsubscribe from this group, send an email to: > [EMAIL PROTECTED] > > c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. > > > ------------------------------------------------------------------------------ The K3UK DIGITAL MODES SPOTTING CLUSTER AT telnet://208.15.25.196/ More info at http:///www.obriensweb.com Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/digitalradio/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
