That assumes the system was still working when the device was removed ....not so this case .. the mother board failed and had to re biuld the pc .. new mother board has 'no' comm ports .. printer or serial ..hence the change to usb>serial
So all the ghosts are still in the machine , mboard pors .. pci-serial .... and the only common one the ft897 cable , which was and still is usb (future proof) is the only bit that wont work .. appart from with HRD .. the usb >printer is fine and the usb 56k modem is ok as well (used for fax) Fldigi will address usb/com4 to work the rig ptt .. but will not communicate with the rig via the usb port G.. --- In [email protected], "Rotten Robbie" <rottenrobb...@...> wrote: > > The solution is to learn how to remove the device from the system before > unplugging it. Look for an icon in your system tray for the item. > > Bob Macklin > K5MYJ > Seattle, Wa. > "Real Radios Glow In The Dark" > ----- Original Message ----- > From: "graham787" <g0...@...> > To: <[email protected]> > Sent: Tuesday, January 05, 2010 1:26 PM > Subject: [digitalradio] Re: HRD will communicate FLDIGI and WSPR will 'not' > via same port > > > > > > > > --- In [email protected], Wes Cosand <wes.cosand@> wrote: > >> > >> On Mon, Jan 4, 2010 at 6:10 PM, graham787 <g0nbd@> wrote: > >> > >> > > >> > > >> > HRD will communicate FLDIGI and WSPR will 'not' via same port > >> > (not at the same time of course) > >> > Odd problem has occured .... using a USB to Serial cable for the > >> > FT-897-D > >> > HRD will communicate normally and control the rig .. > >> > > >> Same thing happened to me when I reassigned a "used" port number to a USB > >> virtual serial port. The rig could use the port but the rotor could > >> not. > >> I had to clean out all the virtual serial ports in the registry and start > >> over. > >> > >> Wes, WZ7I > >> > >> > > >> > BUT > >> > > >> > Fldigi and Wspr .. now will not communicate ..all the settings look the > >> > same ... Fldigi will address a second usb/serial cable alocated com-4 > >> > to > >> > operate the ptt .. as will other progs > >> > WSPR as dose Fldigi reports cannot communicate > >> > > >> > Close then down .. open HRD and the link works normaly .. same cable .. > >> > same settings .. > >> > > >> > All progs used to work with the serial cable ... and ideas ? dose HRD > >> > have > >> > some form of auto baud routine thats masking some setting ?? > >> > > >> > tnx - G . > >> > > >> > > >> > > >> > > Ok Wes. > > > > Is there a simple way to solve the reg problem ?? > > > > tnx - G .. > > > > > > > > ------------------------------------ > > > > Suggested frequencies for calling CQ with experimental digital modes = > > 3584,10147, 14074 USB on your dial plus 1000Hz on waterfall. > > > > Announce your digital presence via our Interactive Sked Pages at > > http://www.obriensweb.com/sked > > Yahoo! Groups Links > > > > > > >
