Hello,
I'm out of office now. but all LEDs on the right side light up. I guess
these are B,D and F.
I will follow the other advices tomorrow, when I'm back in the office.
I the error occured with the images of yesterday (you pushed to the
experimental branch), with the images from 24th of november and with the
images of 14th of August.
Thanks,
Tobias
Am 14.12.2010 18:54, schrieb Josh Blum:
On 12/14/2010 09:39 AM, Tobias Schmid wrote:
Hello,
our institute owns 4 USRP2. Three of them can be pinged.
The 4th one cannot.
It's neither possible to use it with UHD firmware and FPGA image.
If I try uhd_find_device no device is found.
The firmware and the FPGA image on the SD card is working fine.
I checked this using one of my other devices.
Can someone tell me, what the problem might be?
Is it demaged? Is the eeprom demaged?
Or can I solve this problem on my own?
What LEDs light up upon power on? D and F?
Can you attach a serial terminal to the rear and tell me what the USRP2
prints to the terminal at power up?
http://www.ettus.com/uhd_docs/manual/html/usrp2.html#debugging-networking-problems
Can you try an older image set and tell me if the behavior is the same?
http://www.ettus.com/downloads/uhd_images/UHD-images-0000.20100901003255.b5461fc/
Thanks,
-Josh
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
