On 11/28/2012 06:09 PM, Alex Dusowitz wrote: > Hi, > > Has anyone had any problem with setting up MIMO with USRP2? I am trying to > replicate an N210 MIMO setup that I had a while ago and just replaced N210 > with 2 USRP2s. They are connected with a MIMO cable while one of them is > connected with an ethernet cable to the host. Both devices are set with 2 > different IP addresses and I can ping both of them in the MIMO setup. But > when I feed both USRP2s with a sine wave (coming from one source), my scope > sink only shows the signal from one USRP2 (the slave one) and the other > channel shows just noise. Is there any limitation for USRP2s in MIMO > configuration? >
It should work identically. Can you confirm that the devices work as expected when used only in the *single* device case? -josh > Thanks, > Alex > > > > _______________________________________________ > Discuss-gnuradio mailing list > [email protected] > https://lists.gnu.org/mailman/listinfo/discuss-gnuradio > _______________________________________________ Discuss-gnuradio mailing list [email protected] https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
