Seems like my daughterboard's malfunctioning. Thanks for the hint! --Alex
On Wed, Nov 28, 2012 at 9:12 PM, Josh Blum <[email protected]> wrote: > > > On 11/28/2012 06:09 PM, Alex Dusowitz wrote: > > Hi, > > > > Has anyone had any problem with setting up MIMO with USRP2? I am trying > to > > replicate an N210 MIMO setup that I had a while ago and just replaced > N210 > > with 2 USRP2s. They are connected with a MIMO cable while one of them is > > connected with an ethernet cable to the host. Both devices are set with 2 > > different IP addresses and I can ping both of them in the MIMO setup. But > > when I feed both USRP2s with a sine wave (coming from one source), my > scope > > sink only shows the signal from one USRP2 (the slave one) and the other > > channel shows just noise. Is there any limitation for USRP2s in MIMO > > configuration? > > > > It should work identically. Can you confirm that the devices work as > expected when used only in the *single* device case? > > -josh > > > Thanks, > > Alex > > > > > > > > _______________________________________________ > > Discuss-gnuradio mailing list > > [email protected] > > https://lists.gnu.org/mailman/listinfo/discuss-gnuradio > > > > _______________________________________________ > Discuss-gnuradio mailing list > [email protected] > https://lists.gnu.org/mailman/listinfo/discuss-gnuradio >
_______________________________________________ Discuss-gnuradio mailing list [email protected] https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
