Re: [Discuss-gnuradio] setup of usrp N100/N200

Marcus Leech Mon, 21 Oct 2013 07:05:18 -0700

The default IP address of the N2XX devices is 192.168.10.2, so:

uhd_usrp_probe --args "addr=192.168.10.2"

Should work. EXCEPT, you only have a 10/100 Ethernet interface, which won't work. The N2XX devices support ONLY 1GiGe.

on Oct 21, 2013, Sandhya G <[email protected]> wrote:

HI all,

I have followed as per the instructions given in the webpage for set up of the Usrp N200/N210 but still i am unable to communicate between the hardware and host pc

1.I have set the static ip of the host pc to 192.168.10.1(ifconfig eth0 192.168.10.1).

2.Whenever i give the device address=addr=192.168.10.1 and run the grc i am getting the error has “unknown key format”

3.Whenever i ping 192.168.10.2 or use the command uhb_find_device i am getting warning as “NO DEVICE FOUND “

4. Is that a must i have to upload the fpga and firmware images when using the device for the first time.

5.Sometimes i am getting an error like” unable to find as single device”.

6.The host pc is supporting only 10/100MBPS .Is that the only problem so that i am unable to communicate with the hardware.

Can anybody help me on this issue.Awaiting for your valuable reply

Thanks in advance

Sandhya.G

_______________________________________________
Discuss-gnuradio mailing list
[email protected]
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

_______________________________________________
Discuss-gnuradio mailing list
[email protected]
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

Re: [Discuss-gnuradio] setup of usrp N100/N200

Reply via email to