st2000;356897 Wrote: > > Well, I don't have an SB3 - I have an older unit. I turned it on today > > and noticed there is a welcome message despite it not being connected > to > anything. Assuming a normal SB3 works similarly, I'd say you've got > problems that are probably beyond most end users ability to fix. > > I don't think you mentioned, were you connected by cable to your > network? I would try that before giving up. However, not seeing > anything displayed on the VFD is cause for real concern. Now that we > know the low voltage is working the only other 3 possibilities I can > think of are a failed high voltage power inverter for the VFD (not > likely, and you should still be able to see the SB from the server), > the > SB's processor is dead (maybe) or the SB's programming has been > corrupted (that's what I'm thinking now). > > Again, you didn't mentioned, but were you in the middle of upgrading > the > SB's firmware? Pulling the plug on almost any device during this type > > of operation will almost always brick it. Also, upgrading firmware > should most certainly be done while cabled... NOT when operating > wirelessly. > > I can't think of anything else. Anyone else care to comment?
You're right. The SB3 should display something even if the network is down, so there is definitely something wrong. I just did a normal shutdown and then turned it back on a minute later - or tried to. So nothing out of the ordinary. Looks like it's time to contact the shop I bought I from -- supanash ------------------------------------------------------------------------ supanash's Profile: http://forums.slimdevices.com/member.php?userid=15024 View this thread: http://forums.slimdevices.com/showthread.php?t=54629 _______________________________________________ discuss mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/discuss
