Hello, I am trying to set up the Squeezebox Receiver without the need for a controller and having a nightmare. To do this I have done the following; 1. Wire connected my SBR to my Belkin Wireless Router which also is connected to my desktop 2. Turned off the McAfee firewall protection. This is the only way that I can use netUDAP. When the firewall is on, it cannot do the discovery step. 3. Squeezecenter is running on my desktop (192.168.2.2) and iPeng is accessing this server with no problems. 4. When I perform the discovery command using netUDAP, the SBR is found and I configure is as follows;
UDAP [1] (squeezebox 174401)> list bridging: 0 hostname: interface: 0 lan_gateway: 192.168.2.1 lan_ip_mode: 1 lan_network_address: 0.0.0.0 lan_subnet_mask: 255.255.255.0 primary_dns: 0.0.0.0 secondary_dns: 0.0.0.0 server_address: 192.168.2.2 squeezecenter_address: 192.168.2.2 squeezecenter_name: wireless_SSID: 48aGeldeston wireless_channel: 11 wireless_keylen: 0 wireless_mode: 0 wireless_region_id: 14 wireless_wep_key_0: wireless_wep_key_1: wireless_wep_key_2: wireless_wep_key_3: wireless_wep_on: 0 wireless_wpa_cipher: 1 wireless_wpa_mode: 2 wireless_wpa_on: 1 wireless_wpa_psk: <My Password> UDAP [1] (squeezebox 174401)> 5. When I use the save_data and reset commands, everything looks fine but the light on the SBR is yellow. 6. I then unplug the SBR from the router, expecting it to be picked up by the wireless network but nothing happens. 7. I have also opened ports 17784 and 9000 to allow the UDP access to work. Any help with this would be much appreciated. Rich -- rwwebb ------------------------------------------------------------------------ rwwebb's Profile: http://forums.slimdevices.com/member.php?userid=32271 View this thread: http://forums.slimdevices.com/showthread.php?t=57861 _______________________________________________ discuss mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/discuss
