w3wilkes wrote: > Are you sure you're getting the factory reset on the receiver? There are > 2 resets, the first is just a network reset which I've found to be next > to useless. To do the full factory reset on the receiver you must press > and hold the front button on the receiver for about 20 - 30 seconds. You > should notice the LED go to a fast red blink while you're holding the > button and when you release it the LED should go to a solid red. You can > tell that it has been fully factory reset from the controller when you > go to select player, the receiver should be seen by it's MAC address > rather than the name you gave it. I've had my best luck by doing a > factory reset on both the receiver and controller. I did have a issue > one time where the receiver wouldn't go any further than blue LED (got > IP from router, but refused to connect to my Squeezebox server). When > than happened I ended up having to use Net::UDAP to put my server IP and > name in the receiver. I documented that over in the Duet section of the > board.
Yes it was a full reset on the receiver - I waited for red flashing LED changing to rapid red flashing LED. The controller listed the receiver by its MAC address, rather than by its previously assigned name. ------------------------------------------------------------------------ itm's Profile: http://forums.slimdevices.com/member.php?userid=17437 View this thread: http://forums.slimdevices.com/showthread.php?t=96648 _______________________________________________ discuss mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/discuss
