mikeh49 wrote: > Standby. I did exactly this, but I need to do some research to get up > to speed. I used a fixed IP address on the SBC and use it wired. It > may take some time to get it setup wireless, security and password need > some effort, IIRC. If you could run wired, your life will be easier. > You're on the right track to get it working wired first. > > I'm not sure how server address and squeezecenter address work. I > entered values for these, but have since moved servers around, different > addresses, and they always find the SB. The lan_gateway needs to be the > IP of your router. > > Can you post the output of the list command so we can see what you have > set?
thanks for the reply!! there's a good news!! i was able to make the LMS installed on my desktop to recognise the player, when configured for wired-DHCP mode, using the relevant command-line for it on UDAP, ie, -*set interface=1 lan_ip_mode=1 squeezecenter_address=192.168.1.150*- BUT, trying on static IP is tricky! this is what i tried for a wired static IP configuration: 1. went to the IPv4 properties of my network-connection. 2. selected 'Use the following IP address', and put the IP address as *192.168.1.101* (the router still has 'DHCP-enabled'. does it need to be disabled for this config? though i haven't run into any issues so far on thenet, with my desktop having a static IP and DHCP being enabled on the router). 3. then, fired up UDAP, 'discovered' the SBC. 4. now here's the tricky part. am not sure of the values i need to fill in the relevant command-line for this config, ie, -*set interface=1 lan_ip_mode=0 lan_gateway=192.168.3.1 lan_network_address=192.168.3.10 lan_subnet_mask=255.255.255.0 primary_dns=192.168.3.1 squeezecenter_address=192.168.1.150 *- my confusions in this are: * -lan_gateway- i understood is my router's IP-address; -lan_network_address- is i presume the static IP i put, ie, 192.168.1.101, isn't it?! * -primary_dns- should be the actual primary dns i use, ie, *59.185.3.10*, isn't it?! but then, why does the sample show it as the lan-gateway address instead?! * since the LMS is for now installed on my desktop itself, i put in the -squeezecenter_address- as 192.168.1.101. after following the above steps, my connection goes for a toss! i get an IP-conflict error, and can't pull-up any webpages. i didn't take a screenshot of the 'list' command in UDAP, because i first want to make sure what values i need to fill in the above command-line. please suggest what those should be. since now i was successful in making the SBC get detected by squeezecenter, am sure that it can be done by using a static IP as well on the wired-mode. ------------------------------------------------------------------------ TheSeeker's Profile: http://forums.slimdevices.com/member.php?userid=61962 View this thread: http://forums.slimdevices.com/showthread.php?t=57861 _______________________________________________ discuss mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/discuss
