I replied earlier about an RF controlled switch
that would turn the power on and off. There
wasn't much on the device itself (including a
manufacturer name). However, I saw another one
at Home Depot the last time I was there. It's
made by a company called "Commercial Electric"
and had product number 202-620 on it.
Kevin
fcm4711 Wrote:
Hi all
I found a way to switch an amplifier on and off without needing to
decode the ir signal. :) Check it out here:
www(dot)gwendesign(dot)com/slimserver/dev_hard_and_software.htm#ampswitch
Technical background: The plugin switches between audio and blaster
mode causing the right output of the headphone jack to be either low or
floating. That can be used to drive a transistor which in turn drives a
relay.
Cheers
Felix
Hi Felix,
thats good news! Will try to get someone to build that for me :-)
One question , is it possible to build some circuit to accept inputs
from two sources (lets say SB3 and a regular preamp) and output to the
same amplifier, without hurting the "other source device" when you are
using one of the sources? (ie, no current is allowed to go into SB3
when using the preamp as source)
Thanks!
NÈstor
--
NÈstor
Whole album Flac files --> Squeezebox (3) --> direct to Outlaw 7100 amp
using Slimserver Preamp Vol Control --> Monitor Audio S6i
------------------------------------------------------------------------
NÈstor's Profile: http://forums.slimdevices.com/member.php?userid=60
View this thread: http://forums.slimdevices.com/showthread.php?t=17974
_______________________________________________
Discuss mailing list
[email protected]
http://lists.slimdevices.com/lists/listinfo/discuss
--
Kevin O. Lepard
[EMAIL PROTECTED]
Happiness is being 100% Microsoft free.
_______________________________________________
Discuss mailing list
[email protected]
http://lists.slimdevices.com/lists/listinfo/discuss
