The firmware is contained and dictated by what
version of SlimServer you're running.
It most likely did not have version 29 from the
factory as it's still beta. FW 29 is included
with the nightly 6.2.2 releases.
If you download 6.2.1, the stable release, through
the normal channel, it contains firmware 28 and
will load it on your Squeezebox at the first
opportunity.
So, what version of SlimServer were you running?
Did you change it?
Looks like it got a bit confused going back and
forth. But the good thing is I haven't seen
anyone "brick it" like what's possible with a router.
cvj wrote:
> Yesterday, My wireless SB3 greeted me with the
upgrade/download new
> firmware message.
>
> As instructed, I pressed the brightness button on
the remote...and the
> download/install began.... however, at the
conclusion of the process,
> instead of starting up normally, I was sent back to
the
> upgrade/download screen again...
>
> I did the process a couple of times...then tossed in
the towel and
> called tech support at Slim Devices. They solved the
problem by having
> me unplug the power supply and then press the "1"
button on the remote
> as I plugged the power supply back in the SB3.
>
> Interestingly, the SB3 firmware "upgrade" actually
rolled back from
> version 29 BETA (installed at the factory) to
version 28.
>
> Anyone else get this mysterious upgrade???
>
> Cheers
>
>
--
___________________________________
Mark Lanctot
___________________________________
__________________________________________________________
Find your next car at http://autos.yahoo.ca
_______________________________________________
Discuss mailing list
[email protected]
http://lists.slimdevices.com/lists/listinfo/discuss
