Hello
Dear all
I have the following question:
I want the openvswitch reads the exchanged packets and deal with them as they
are sent to it.
To do so, I did the following:
I
installed a flow-entry in the switch that matches the packet address,
then rewrite it to the local bridge address of the switch.
To test this:
1. I connected two hosts with a switch in between
2. the first host ping the second host, however
3.
the controller inserts two flow entries one in the switch to catch the
packet and rewrite it with the switch address and another in the host to
rewrite the source address of incoming packet with the address of the
second host, to let it think the respond is coming from the second host
"intended one" not from the switch.
4. I run their interfaces in promisc mode.
5. working with IP addresses
However, it is not working with me
Is there something wrong with this procedure.
Any help will be appreciated
Best regards,
Eng Amer Alghadhban
COE
SANS-GCFW
CEH, SCNP, CCNA
_______________________________________________
discuss mailing list
[email protected]
http://openvswitch.org/mailman/listinfo/discuss
