Make sure you are not using Mininet’s TCLink (—link tc) — it currently conflicts with OVS’s use of tc, and vice-versa.
> On Apr 29, 2015, at 11:52 PM, Haleema Sadia Mahmood > <[email protected]> wrote: > > Hey everyone, > > So I am trying to configure queues on a mininet topology. The command that I > use is, (here s1-eth1 is my port 1) > > sudo ovs-vsctl set port s1-eth1 qos=@newqos - - - -id=@newqos create qos > type=linux-htb queues=0=@q0 - - - -id=@q0 create queue > other-config:max-rate=100000000 other-config:min-rate=5000000 - - > > The qos is attached to the port, checked it from sudo ovs-vsctl list port > s1-eth1, and the queues are created. > > But when I try to use the command > sudo ovs-ofctl queue-stats s1 s1-eth1 -O OpenFlow13 > > it returns : OFPST_QUEUE reply (OF1.3) (xid=0x4): 0 queues > > And when I try > sudo ovs-ofctl queue-stats s1 -O OpenFlow13 > > it returns: OFPST_QUEUE reply (OF1.3) (xid=0x2): 0 queues > > I am using OVS 2.3.90, and the version of OpenFlow version is 1.3. > > Also when I try to check the queues with iperf sending udp packets on the > queue created, the rate is not limited on the queue. > > Any ideas what am I missing while setting this queue? > > Thanks! > > Best, > Haleema > _______________________________________________ > discuss mailing list > [email protected] > http://openvswitch.org/mailman/listinfo/discuss
_______________________________________________ discuss mailing list [email protected] http://openvswitch.org/mailman/listinfo/discuss
