[oops, replied to an old message by mistake - apologies -BL] > On Nov 30, 2015, at 9:56 PM, Bob Lantz <[email protected]> wrote: > > Make sure you are not using Mininet’s TCLink (—link tc) — it currently > conflicts with OVS’s use of tc, and vice-versa. > >> On Apr 29, 2015, at 11:52 PM, Haleema Sadia Mahmood >> <[email protected] <mailto:[email protected]>> wrote: >> >> Hey everyone, >> >> So I am trying to configure queues on a mininet topology. The command that I >> use is, (here s1-eth1 is my port 1) >> >> sudo ovs-vsctl set port s1-eth1 qos=@newqos - - - -id=@newqos create qos >> type=linux-htb queues=0=@q0 - - - -id=@q0 create queue >> other-config:max-rate=100000000 other-config:min-rate=5000000 - - >> >> The qos is attached to the port, checked it from sudo ovs-vsctl list port >> s1-eth1, and the queues are created. >> >> But when I try to use the command >> sudo ovs-ofctl queue-stats s1 s1-eth1 -O OpenFlow13 >> >> it returns : OFPST_QUEUE reply (OF1.3) (xid=0x4): 0 queues >> >> And when I try >> sudo ovs-ofctl queue-stats s1 -O OpenFlow13 >> >> it returns: OFPST_QUEUE reply (OF1.3) (xid=0x2): 0 queues >> >> I am using OVS 2.3.90, and the version of OpenFlow version is 1.3. >> >> Also when I try to check the queues with iperf sending udp packets on the >> queue created, the rate is not limited on the queue. >> >> Any ideas what am I missing while setting this queue? >> >> Thanks! >> >> Best, >> Haleema >> _______________________________________________ >> discuss mailing list >> [email protected] <mailto:[email protected]> >> http://openvswitch.org/mailman/listinfo/discuss > > _______________________________________________ > discuss mailing list > [email protected] > http://openvswitch.org/mailman/listinfo/discuss
_______________________________________________ discuss mailing list [email protected] http://openvswitch.org/mailman/listinfo/discuss
