making the logo work on hardware is super important, so go for it! please put up the ideas/decision on a wiki page...want to get this up and out by monday actually for m1 launch
On Fri, Sep 2, 2011 at 7:16 PM, Werner Almesberger <[email protected]> wrote: > Allin Kahrl wrote: >> By aliasing it and knocking a pixel out of the >> tail like my attached .png? > > That looks ugly. I don't think a pixels -> mill -> pixels process > makes much sense, since you'll never get back the same result. > > I'd rather have one original ideal geometry and then a set of > derived (*) geometries for processes that can't approximate the > ideal geometry with sufficient accuracy. > > (*) "Simple paths" and "constant radius" converge with the > pixelated original for tool diameter -> 0. "Constant width" > may or may not, depending on how the curvature is defined. > > - Werner > > _______________________________________________ > Qi Hardware Discussion List > Mail to list (members only): [email protected] > Subscribe or Unsubscribe: > http://lists.en.qi-hardware.com/mailman/listinfo/discussion > -- Jon Phillips http://fabricatorz.com/ chat/skype: kidproto | irc: rejon +1.415.830.3884 (global) | +1-510-499-0894 (sf) +86-187-1003-9974 (beijing) _______________________________________________ Qi Hardware Discussion List Mail to list (members only): [email protected] Subscribe or Unsubscribe: http://lists.en.qi-hardware.com/mailman/listinfo/discussion
