Felix wrote: > That last iteration its incredible! Thanks ! :) And I had quite a bit of room left when I got to the RF side. I actually trimmed the board by another 1 mm, which is as far as a I dare to go, lest the antenna end up below the OLED.
> One question about the capacitive sensor, does it works with the thick > player of plastic that will be the case? It'll just be about 1 mm. The board is meant to be cut at the slot between battery and the main circuit, and the sub-board is attached to the top of the case. This is the vertical stacking: https://gitorious.org/anelok/anelok/source/me/STACKING In the first experiment with capacitive sensing on the KL26 (the video with the Y-Box), I also had about 1 mm of plastic on top of the sensor, and it was quite responsive. - Werner _______________________________________________ Qi Hardware Discussion List Mail to list (members only): [email protected] Subscribe or Unsubscribe: http://lists.en.qi-hardware.com/mailman/listinfo/discussion
