This used to be a problem on older versions but was fixed in the 0.80.0 series. Look for the milestone that says its fixed and use a version after that.
On 8/29/05, Rodolfo Vardelli <[EMAIL PROTECTED]> wrote: > Scott Ullrich ha scritto: > > the webgui is unusable (also ssh), I will use serial > I noticed another problem with load balance: > I have two wan and a wireless lan connected to the soekris, with load > balance enabled > when I try to reach a wireless access point, every packet is directed to > one of the ip of the outbound pool, > so I have to add a static route to connect to an access point. > > regards > Rodolfo > > >Run top when it happens from a serial console or from exec.php and > >show us the output. > > > >Scott > > > > > >On 8/29/05, Rodolfo Vardelli <[EMAIL PROTECTED]> wrote: > > > > > >>I installed 80.4 on a couple os soekris 4801. > >>With carp and and outbound load balance enabled. > >>Everything works, but after a couple of minutes, cpu usage goes to 100% > >>on master and bakcup. > >>When I reboot the backup cpu usage return to normal, but again after 2-3 > >>minutes return to 100%. > >> > >>I suspect carp+outbound load balance. > >> > >> > >>regards > >> > >> > >> > > > > > > > > > >
