Scott Ullrich ha scritto:
with load balance I can only use 0.80.4
regards
Rodolfo
This used to be a problem on older versions but was fixed in the
0.80.0 series. Look for the milestone that says its fixed and use a
version after that.
On 8/29/05, Rodolfo Vardelli <[EMAIL PROTECTED]> wrote:
Scott Ullrich ha scritto:
the webgui is unusable (also ssh), I will use serial
I noticed another problem with load balance:
I have two wan and a wireless lan connected to the soekris, with load
balance enabled
when I try to reach a wireless access point, every packet is directed to
one of the ip of the outbound pool,
so I have to add a static route to connect to an access point.
regards
Rodolfo
Run top when it happens from a serial console or from exec.php and
show us the output.
Scott
On 8/29/05, Rodolfo Vardelli <[EMAIL PROTECTED]> wrote:
I installed 80.4 on a couple os soekris 4801.
With carp and and outbound load balance enabled.
Everything works, but after a couple of minutes, cpu usage goes to 100%
on master and bakcup.
When I reboot the backup cpu usage return to normal, but again after 2-3
minutes return to 100%.
I suspect carp+outbound load balance.
regards
