Hi Guys, ( pippin, paul- and others )
Many thanks for this development and added functionality ! Tonight I got this up and running on my test pi ( Pi0w with pcp350 ) in a relative short time. Most time was used to solder a few extra pins to my proto-hat and figure out what needed to be connected to what physical GPIO pin. The button function was the easiest, as it really needs 1 pin and ground. My rotary encoder needed 3.3v and ground, perhaps due to built in resistors, and missing options to set Pi side pullup/pulldown resistor function. But hey, just 1 extra lead to solder and success, and it fulfilled one of my PCP wishes. One question comes to mind reading the readme file and this thread; WHY ARE WE LIMITING TO 1 ENCODER ATM ? I would like to see a second encoder control the user interface on a small screen. Roll and click like the already ancient blackberries! Slimmer is probably the smart choice for that. But other people might come up with even better suggestions to use a second and third rotary encoder. With this SqueezeButtonPi project reaching maturity, I would vote for building it into the PCP gui pages/scripts. With well chosen defaults we can offer this functionality to less experienced users who just want to buy standard components and enable this from the menu. This could be all in an extension . Regards M-H Pi based multi-room audio system powered by PiCorePlayer(s): Pi3B with Phat-dac in a Rasptouch, 2 pi B+ with Cirrus Logic Audio Card, Pi Zero with Phat-beat , and a few other tests... ------------------------------------------------------------------------ M-H's Profile: http://forums.slimdevices.com/member.php?userid=66156 View this thread: http://forums.slimdevices.com/showthread.php?t=107001 _______________________________________________ diy mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/diy
