paul- wrote: > Are you compiling your own version? Source code is currently in my > github, I've never merged back to pippen's git. No I am happy with the version you compiled for me / us. But if your additions can be incorporated in Pipins version, there are fewer things to go wrong for people who do not read source files for breakfast. :-)
paul- wrote: > > VOLU is the correct command. When I set all that up, we tested with 3 > wire encoders, using ground as the center tap. The gpio pins are set > with pullup resistors, and we need to used both rising and falling edges > to properly detect changes. The volume appears to be changing from > your log.....perhaps not as fast as you want. Haha -1 -1 +1 -1 +1 -1 +1 = -1 that is indeed not fast enough for me, As all rotary clicks were in the same direction. But as I tested with the same wire setup you used, I will triple check the encoders datasheets and verify with a faster pi. This was all done on a B+, and fast turns seemed to have undetected clicks. So a detection performance issue might be at hand. And I should also eliminate the sound card, just to be on the safe side. M-H Pi based multi-room audio system powered by PiCorePlayer(s): Pi3B with Phat-dac in a Rasptouch, 2 pi B+ with Cirrus Logic Audio Card, Pi Zero with Phat-beat , and a few other tests... ------------------------------------------------------------------------ M-H's Profile: http://forums.slimdevices.com/member.php?userid=66156 View this thread: http://forums.slimdevices.com/showthread.php?t=107001 _______________________________________________ diy mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/diy
