Jursi wrote: > Thank you very much, everything is working now. > > Finally I have a player in my bathroom/sauna with physical control. > Physical controls are important because it is hard to use touch screen > with wet hands when I am in sauna/shower or in a hot tube. And the cheap > touch screen is almost unusable anyways. > > Here is a picture of my "prototype" player. It is not the prettiest but > it sure gets the job done! https://imgur.com/a/bG1HApc > Sad that there is no 3.5 inch display with bezel/frame like there is in > the official 7inch display. It hard to cut a proper hole with a dremel:D
Hi, I have a similar radio in kitchen with an 5'' display but the physical control is important due to the same reasons. Following the instructions found here I managed to configure two rotary encoders and buttons. The only missing thing is the LCD backlight control. I would like to drive the LCD backlight control GPIO port to switch off the backlight when the player is stopped. With sbpd b,13,POWR command the top row of jivelite shows "Off" when the button is pressed. I expected it would control the Poweroff GPIO configured in Poweroff/Shutdown Overlays section of piCorePlayer configuration page, however it does not fly, the configured GPIO pin does nothing. Could you please recommend a solution to configure a simulated power on/off behavior with stopping/starting player and LCD backlight control? ------------------------------------------------------------------------ sakos's Profile: http://forums.slimdevices.com/member.php?userid=70470 View this thread: http://forums.slimdevices.com/showthread.php?t=107001 _______________________________________________ diy mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/diy
