I now realize you are not in OZ so yes contact Gerlinde Limbach [email protected] <mailto:[email protected]>
Your element is the blue colured polymer which it the later material I.W. mentions. Still suffers from the additives in engine oil. The manual describes it as “damper, toothed” and the part number is 170.125.001 If it is registered experimental and you want to use general engineering supply with no release note then as I.W. says it is readily available. However the durometer hardness must be observed to maintain integrity re fatigue. Nige. From: [email protected] <[email protected]> On Behalf Of Ian Williams Sent: Friday, February 14, 2020 7:31 PM To: [email protected]; [email protected]; [email protected] Subject: RE: [DOG mailing list] Rubber Magneto Mount Yep, I had a similar problem but found a standard Jaw coupling was the same. In fact better as it used modern material able to tolerate the heat better . I would suggest that if the Dimona has been sitting around for a number of years, you replace the condenser (if a Slick mag) as we had a condenser failure even after a bench check. Best regards Ian Williams ZK-GCB From: [email protected] <mailto:[email protected]> Sent: Friday, 14 February 2020 1:30 p.m. To: [email protected] <mailto:[email protected]> ; [email protected] <mailto:[email protected]> Subject: Re: [DOG mailing list] Rubber Magneto Mount Sorry, Tampa, Florida -----Original Message----- From: Laurie Hoffman via dog <[email protected] <mailto:[email protected]> > To: [email protected] <mailto:[email protected]> <[email protected] <mailto:[email protected]> > Sent: Thu, Feb 13, 2020 5:49 pm Subject: Re: [DOG mailing list] Rubber Magneto Mount Where are you located? Laurie Sent from Yahoo7 Mail on Android <https://go.onelink.me/107872968?pid=InProduct&c=Global_Internal_YGrowth_AndroidEmailSig__AndroidUsers&af_wl=ym&af_sub1=Internal&af_sub2=Global_YGrowth&af_sub3=EmailSignature> On Fri., 14 Feb. 2020 at 9:17 am, pattoninfl.aol.com via dog <[email protected] <mailto:[email protected]> > wrote: All, See attached. We are restoring our H36 Dimona that has been sitting for many years. Today we pulled the magneto. The rubber mount has rotted away. Can anyone give directions where I can purchase a replacement? --------------------------------------------------------------------- You are subscribed to the Dimona Owners Group mailing list. To unsubscribe, send email to: [email protected] <mailto:[email protected]> --------------------------------------------------------------------- You are subscribed to the Dimona Owners Group mailing list. To unsubscribe, send email to: [email protected] <mailto:[email protected]>
