I have seen something similar. I think it is caused by the v brace wires being a little over tightened and over time the rubber bends towards the front. regards Rob
Rob Thompson 0429 493 828 (Please note that my new email address is [email protected]) On Sat, Apr 18, 2020 at 1:42 PM Tom Preisser <[email protected]> wrote: > Hope everyone is well, > I am replacing my rear motor mounts, just for fun as the originals are > perfectly fine , with spares from the Thai Air Force. > I noticed something odd about the originals - although they are identical > (i.e. not left or right handed), the rubber bit is sloped oppositely. Thus > the flange notch, the offset stud which fastens to the frame, everything is > identical except for the sloped side which is mirror symmetrical. > I've looked at vanagon parts and they don't mention handedness, nor have > different part numbers. > Installed new blocks okay (no slope on them ) everything seems fine, motor > sits the same. > Is there a right hand/left hand issue here ? > Any thoughts? > Two photos attached. > > --------------------------------------------------------------------- > You are subscribed to the Dimona Owners Group mailing list. > To unsubscribe, send email to: [email protected]
