Thank you all so much. Regards Jarek
On Thu, 17 Jun 2021 at 05:32, Rob Thompson <[email protected]> wrote: > It may be possible to just glue a new bush and the metal fitting back in > without cutting into the top glass in the fin. Bit hard to tell from just > the images. > regards > Rob > > Rob Thompson > 0429 493 828 > (Please note that my new email address is [email protected]) > > > On Thu, Jun 17, 2021 at 12:29 PM Rob Thompson <[email protected]> > wrote: > >> The h36 has lots of timber bits that are glassed in place. It is not >> uncommon for moisture to get into the timber and it goes soft. >> >> This pin just stops the tail plane from sliding forward and disengaging >> the pins from the bearings. >> >> When you are flying the tailplane is forced backwards and held in place >> even without this pin. The tailplane which fell off in Australia was >> taxying over bumpy ground. >> >> In this case the wood is just a spacer and bushing between the outer >> glass skins. I would just cut the top of the fin, glue in a chunky new >> nylon bush, refit the metal top piece and then do a standard fibreglass >> repair to the top as per the manual. >> >> regards >> Rob >> >> Rob Thompson >> 0429 493 828 >> >> >> >> On Thu, Jun 17, 2021 at 7:45 AM Ian Mc Phee <[email protected]> wrote: >> >>> Does not look good >>> >>> Years ago I had one similar (not as bad) and just rebuilt the whole >>> lot. First attempt was not right but second go it worked. Think spring >>> length was the issue. I also added to outside of tube which anchored it >>> much better when I remounted it and re glued with resin and flock. >>> >>> Let me search. I think I have a copy of drawings. When I asked diamond >>> they did not know which one was fitted to this sr no. Basically think sr >>> no 1 to 4 had a basic system and all others are the same system. They >>> replied overnight through my friend who is a diamond service centre in >>> Australia. >>> >>> Ian McPhee >>> 0428847642 >>> Box 657 Byron Bay NSW 2481 >>> >>> On Thu, 17 Jun. 2021, 05:40 Jarek Steliga, <[email protected]> >>> wrote: >>> >>>> VID_20210614_094632.mp4 >>>> <https://drive.google.com/file/d/1msjSBPnUsY9j7had5VkRO3bOhBj625FD/view?usp=drive_web> >>>> Hello, >>>> >>>> I took some photos and a video two days ago. Please advise how best to >>>> deal with the situation. >>>> >>>> >>>> >>>> Regards >>>> Jarek >>>> >>>
