We've laser-cut pre-coated plastic and glass at PSU to form traces. Worked fine.
On Wed, Oct 15, 2014 at 5:00 PM, Jerry Biehler <[email protected]> wrote: > Don't even think of using something like that for a bell jar. > > -Jerry > > > On Wednesday, October 15, 2014, Adam Hunt <[email protected]> wrote: >> >> http://www.williams-sonoma.com/products/2579332/?catalogId=52&sku=2579332 >> >> On Wed, Oct 15, 2014 at 4:39 PM, Nathan McCorkle <[email protected]> wrote: >>> >>> >>> >>> On Wed, Oct 15, 2014 at 4:09 PM, Jerry Biehler <[email protected]> >>> wrote: >>>> >>>> Electroplating to carbon will never stick. Best bet is sputtering glass >>>> with copper and then etching as a normal pcb. >>> >>> >>> I wanted to avoid sputtering in general, since I'm not sure where I'd >>> find a >12 inch bell jar/vac chamber. Unless I had one (TIG?) welded or >>> something. I figure a liquid chamber would be easier to manage. >>> >>> Also plastic is more of interest at this point, just since it wouldn't >>> shatter/crack as easily. >>> >>> _______________________________________________ >>> dorkbotpdx-blabber mailing list >>> [email protected] >>> http://music.columbia.edu/mailman/listinfo/dorkbotpdx-blabber >> >> > > _______________________________________________ > dorkbotpdx-blabber mailing list > [email protected] > http://music.columbia.edu/mailman/listinfo/dorkbotpdx-blabber _______________________________________________ dorkbotpdx-blabber mailing list [email protected] http://music.columbia.edu/mailman/listinfo/dorkbotpdx-blabber
