I live and work in Hillsboro, near Cornelius pass road. Let me know if the plan with Manny doesn't work out. I have both 3mm and 1.75mm. Jason
On Wed, Dec 3, 2014, 11:31 AM Manuel Muro <[email protected]> wrote: > Hi Andrew, > > I can give you some as my printer uses 3mm filament. I also work in > Hillsboro/North Plains area, but since I have an off-site meeting tomorrow > I will not be able to connect up with you until Friday, does that work for > you? If so, send me a message directly. > > - Manny > > > On Wed, Dec 3, 2014 at 10:57 AM, Dawes, Andrew M. <[email protected]> > wrote: > >> Does anyone on the west side (Hillsboro etc) have some 3mm PLA I could >> try just to make sure (just need a few feet). >> >> I built a new Kossel from a kit and thought it was 1.75mm but it looks >> like in uses 3mm (RTFM right?). >> >> This printer kit has been a bit of a nightmare so I am hesitant to >> invest any more time/money until I know I’ve solved the problem. >> >> For what it’s worth, the extruder drive has a tension bearing that fits >> the 1.75mm filament very nicely so that is what I ordered. However, now >> that I try to print, the filament backs up inside the extruder and when I >> pull out the plug of molten PLA, it measures 3mm. I suspect using the right >> filament will solve my problems. >> >> Thanks, >> Andy >> >> -- >> Andrew M.C. Dawes >> Associate Professor of Physics >> Pacific University >> amcdawes.com >> >> >> _______________________________________________ >> dorkbotpdx-blabber mailing list >> [email protected] >> http://music.columbia.edu/mailman/listinfo/dorkbotpdx-blabber >> > > _______________________________________________ > dorkbotpdx-blabber mailing list > [email protected] > http://music.columbia.edu/mailman/listinfo/dorkbotpdx-blabber
_______________________________________________ dorkbotpdx-blabber mailing list [email protected] http://music.columbia.edu/mailman/listinfo/dorkbotpdx-blabber
