"sebdesn" <[EMAIL PROTECTED]> made an utterence to the drakelist gang
----------------------------------------------------------------------
-------------------------------------------------
> The knob is a plastic cylinder that fits on the ends of the two metal
> lever switches.
> The cylinder is plastic, about 1/2 in long and maybe 1/4 in diameter
> (I'll have to dig the broken ones out of the drawer to measure).
> They just slip over the flat metal lever and are held on by friction.
> They have a nasty habit of cracking along the length of the cylinder
> and are small enough that any glue job is almost certainly doomed.
Sterling,
This is a website that sells 1/4" ABS rod, all you need to do is, put a
longer than you need chunk in a drill and round the end and polish it,(use
fine sand paper and rubbing compound), cut it off to length drill a suitable
hole in the other end for the switch,and viola, you be done...That is
assuming there are no other ridges etc to make...
Bud Schieving W�HG
http://www.k-mac-plastics.net/abs-rod.htm
----------------------------------------------------------------------
On Behalf of "sebdesn" <[EMAIL PROTECTED]>
Submissions: [EMAIL PROTECTED]
Unsubscribe: [EMAIL PROTECTED] - unsubscribe drakelist in body
Hopelessly Lost: [EMAIL PROTECTED] - help in body of message
Zerobeat Web Page: http://www.zerobeat.net
Brought to you courtesy of TLCHost.net http://www.tlchost.net/
----------------------------------------------------------------------
