"MNACE" <[EMAIL PROTECTED]> made an utterance to the drakelist gang ---------------------------------------------------------------------- Dear folks, I was just aligning a TR-3, and the 8A fuse blew. This fuse had always looked pretty bad anyway. I suppose it gets a certain amount of abuse from the surge until the filaments get up past their cold resistance. I have replaced it with a 8A slow blow, and the alignment now in the final steps. Is this OK, or should I use fast-acting fuse??? I suppose there could be a filament-to-cathode short on a tube also that would cause this ???
Thanks fellows, Mark N5KAE ---------------------------------------------------------------------- Submissions: [email protected] Unsubscribe: [EMAIL PROTECTED] - unsubscribe drakelist in body Hopelessly Lost: [EMAIL PROTECTED] - help in body of message Zerobeat Web Page: www.zerobeat.net - sponsored by www.tlchost.net ----------------------------------------------------------------------
