"sebdesn" <[EMAIL PROTECTED]> made an utterance to the drakelist gang ----------------------------------------------------------------------
> > Bottom line is, if you short Pins 1 and 2 of the Control connector > together with a piece of paper clip, you'll have ~30A of > 13.6VDC at Pins > 13/15 (+) with the return via Pins 12/14 (-). > Since those two pins have 120v on em I use a 6pin male plug,The two end pins are shorted internally. Those two pins go into the 2 pins needed to turn it on,on the 10 pin plug. The two pins that need to be closed on the 10 pin plug and the 6 pin plug,shorted pins are on the ends so the plugs only have those two connections between them...hope thats clear?? Mark the two plugs with some whiteout so you get em in correctly. To get the DC out I soldered a#10 insulated wire to a tab that slips in the end of the DC out put plug and thence to the load... I read this three times and it may or not make sense..If it doesnt I will draw a pic and scan it for whoever needs it.. 73 de Bud WØHG ---------------------------------------------------------------------- Submissions: [EMAIL PROTECTED] Unsubscribe: [EMAIL PROTECTED] - unsubscribe drakelist in body Hopelessly Lost: [EMAIL PROTECTED] - help in body of message Zerobeat Web Page: www.zerobeat.net - sponsored by www.tlchost.net ----------------------------------------------------------------------
