Mark Pilant <[EMAIL PROTECTED]> made an utterance to the drakelist gang ---------------------------------------------------------------------- Hi Rich.
> Where did you measure? Pin 6 of V1b? The mV measurements I got were taken, using my scope, from pin 3 of V1b. I wanted to try and pick a spot as soon after the oscillator with the least likelihood of loading from the scope probe. I wasn't too concerned about the absolute amplitude of any particular band, but was more interested in the relative comparison. All three 10m crystals were quite a bit above the 40m and 15m crystals. I also took some additional measurements at the junction of R13, R15, and C24. R15 is connected to the grid (pin 9) of V3a and R13 is connected to the cathode (pin 8) of V3a. Again, looking at the relative amplitude the 40m and 15m oscillator output through the cathode follower it was obvious the 40m and 15m signals were down more than the 10m signals. 73 - Mark N1VQW ---------------------------------------------------------------------- Submissions: [EMAIL PROTECTED] Unsubscribe: [EMAIL PROTECTED] - unsubscribe drakelist in body Hopelessly Lost: [EMAIL PROTECTED] - help in body of message Zerobeat Web Page: www.zerobeat.net - sponsored by www.tlchost.net ----------------------------------------------------------------------
