My TR-7 has developed a frequency problem. When turned on with the
bandswitch on 160m, the frequency readout showed a frequency of 17600-17800 Khz
and
was jittery. After warmup of a half hour or so, it would start working and and
show 1870 Khz like it should. Now, it doesn't show 1870 khz at all and stays
in the 17600-17800 range even after warm up. Neither the RX or TX is working.
However when I push the RCT button and go to my R-7 for frequency control,
everything is working correctly and I am on 1870 Khz and the RX and TX is fine.
When I switch to transmit the TR-7 readout shows 1870 Khz. When I go to RX
then it goes back to 17600-17800 Khz. So where should I start looking in the
TR-7 to find the problem? Is this a known problem that someone else has
experienced or a new one? Any help someone could offer would be appreciated.
Terry,
W8NJR
**************Make your life easier with all your friends, email, and
favorite sites in one place. Try it now.
(http://www.aol.com/?optin=new-dp&icid=aolcom40vanity&ncid=emlcntaolcom00000010)
_______________________________________________
Drakelist mailing list
[email protected]
http://mailman.zerobeat.net/mailman/listinfo/drakelist
