Bob -
Seems like we've already had this discussion once before.......
Again, I'm sure glad _"I'VE_ never done anything that stupid...... :-)
73, Garey - K4OAH
Glen Allen, VA
Drake 2-B, 4-B, C-Line & TR-4/C Service Supplement CDs
<www.k4oah.com>
Robert Ladden wrote:
Call me an idiot!
Everybody: You're an idiot!
When I took off the covers, I also removed the remote VFO plug. I
forgot to put it back. The TR-3 needs it jumpered.
I finally figured this out when taking resistance measurements and pin
7 of V2 should be 7 Ohms. It measured open. Imagine how I felt when I
followed the line on the schematic to the VFO plug. Both joy and
embarrassment.
So back to the real work.
73,
Bob WW3QB
At 02:02 PM 1/3/2009, you wrote:
After getting my TR-3 to partially work and having a QSO on 80M last
night, this morning the TR-3 will not receive. It just hears the
calibrator when the sideband switch is in the X position. The VFO has
no effect. There is no voltage at the V1 test point, so I lost the
oscillator. I did not even do anything to it yet. I was going to
start the alignment procedure and took the covers off. It's the same
on all bands. It's a shame since it was so close. What do I check for?
73,
Bob WW3QB
_______________________________________________
Drakelist mailing list
[email protected]
http://mailman.zerobeat.net/mailman/listinfo/drakelist
