It's great to see you back Garey! I Hope the recovery is going well.  73,
                                                                            
                            Terry,  W8NJR
 
 
In a message dated 9/5/2009 2:21:44 P.M. Eastern Daylight Time,  
[email protected] writes:

Phil

Your unit is built to schematic 27500, and should have  6EJ7, 6BA6, and
6BZ6.  Earlier units (27000) had the 12V  tubes.

73, Garey - K4OAH



Walker wrote:
> I have a  TR-4, 1968 manufacture date, serial number 28124. It has worked 
> well  for years, with the last few being dormant as my vertical took a 
> hit  a few winters ago with icing. I've replaced the vertical, and I'm 
>  trying to re-tube the unit. Here is where the confusion arises:
>   
> The chassis lettering and schematic for tubes V4, V5, V11 and both  agree 
> and are respectively: 6EJ7, 6BA6, 6BZ6.
>  
>  Note: the schematic has V5 and V11 with a hand lettered "6" in front of  
> 6BA6 and 6BZ6 versus all other tubes which have stencil guided  lettering.
>  
> The Manual's Voltage Reference chart and  Tube List for V4, V5 and V11 
> are: 6EJ7, 12BA6, 12BZ6
>   
> The Manual's Block Diagram shows V4 as 6HS6
>  
>  I'm not sure what's supposed to be right, though I have a tendency to 
>  believe the chassis lettering and schematic. The manual is internally 
>  inconsistent, and doesn't agree with the physical hardware or schematic. 
 
> I probably can take out V5 and V11 and measure the filament voltage  
> present to see if it really is set up for a 6 or 12 volt tube in  those 
> sockets.
>  
> I found some correspondence  between the original owner, whom I purchased 
> the unit from, and the  factory regarding a technical problem. The 
> factory rep wasn't sure in  solving a problem whether the former owner 
> needed a 6BZ6 or a 12BZ6  so he sent him one of each. Apparently the 
> factory didn't know  either!
>  
> Was there some changeover for different serial  number ranges, between 
> various tube types or what, and what is the  best way to tell which tubes 
> really belong in the  circuits?
>  
> Thanks for pointing me toward a resource, if  you know one, to help get 
> some answers.
>  
> Phil  WA2CLX
>  


_______________________________________________
Drakelist  mailing  list
[email protected]
http://mailman.zerobeat.net/mailman/listinfo/drakelist


_______________________________________________
Drakelist mailing list
[email protected]
http://mailman.zerobeat.net/mailman/listinfo/drakelist

Reply via email to