Luther -
The problem just about has to be with that stage or the associated
switching. If you have an external general coverage receiver, you can
tune it to 21.5 MHz and see if you can hear the 40 Meter BAND crystal.
You may need a wire from the external receiver antenna jack and bring
the other end near the crystals on the TR-4C. If you do NOT hear the
signal at 21.5, with the BAND switch set to 40M, the oscillator isn't
running.
73, Garey - K4OAH
Glen Allen, VA
Drake 2-B, 4-B, C-Line& TR-4/C Service Supplement CDs
<www.k4oah.com>
Luther Nallie wrote:
Thank you guys for the responses to my problem, which was, I can only
get 20 and 80m on my TR4Cw. Taking the advice from the list I
replaced the 6EA8 (V1) tube which didn't change anything. I then
looked for broken solder joints and wires that had pulled loose. So I
wonder what should be the next step to try to figure this out. This
doesn't bother me a whole lot since all I work is 80 and 20 anyway,
but would like to get the rig working all the way if I can. I do
appreciate the help.
_______________________________________________
Drakelist mailing list
[email protected]
http://mailman.zerobeat.net/mailman/listinfo/drakelist
