Drake items for sale:
Drake TV-3300-LP Low Pass Filter This is a modern low pass filter to go between your transmitter and antenna, and has been optimized to have more attenuation in the 40 MHz region, where many TVs have their IF. It is good for 1000 Watts "average" according to the manual, and has over 80 db attenuation at 41 MHz. This one looks great, and includes the paper work. $30 Drake TV-5200-LP This is the more modern version of the Drake TV-1000 Low Pass Filter. This is the filter that may also be used on the low end of six meters, as well as HF. It is good for 1000 Watts average below 30 MHz, and about 200 W up to 52 MHz. It works fine, and is in very nice shape. $35 Case for Drake TR-33 C This is the black case that fits the Drake TR-33 C, and has cutouts in the back for antenna, power, etc. It includes the shoulder strap, and is in good shape. $12 Case for Drake TR-22 As above, but for the TR-22. No shoulder strap. $10 3 pin mic plug for TR-22 This is the small 3 pin mic plug that fits the Drake TR-22 mic jack. It is much smaller than most of the mic connectors. I thought these were completely gone, but one appeared from a silent key. This one has been used, but should still be usable some more. $10 Communications Speaker This 4 inch square speaker is optimized for communications frequencies (300 to 3000 Hz). It is in a black enclosure, and is an 8 ohm speaker. It has a cord with a 1/8 inch (3.5 mm) mono plug on the end. This one works fine and looks OK also. $15 Microphones: All of these microphones have been tested and work well. Shure 401 B, Low Z Hand Microphone This mic has characteristics similar the the Shure 444 Desk Mic, but this one is a hand mic. It is a controlled magnetic mic, with frequency response tailored for voice communications. It has a rugged case, and a heavy duty coiled cord. 4 pin connector. With paper work for $40. Shure 104 C, Low Z hand Microphone This is a very heavy duty Shure mic. It appears to be new, with stripped and tinned ends that have never been on a connector. It is in its original box, with the original instruction manual. $30 Chrome Low Z Hand Microphone This mic is chrome plated. My memory says it may have come from a Polycom rig. The mic is a good solid metal case with chrome plating all around, with a black PTT switch and black coiled cord. There are some pits on the chrome; it works fine. $30 Generic Hand Microphone This is a low impedance hand microphone, black in color. With 4 pin connector. $25 With no connector. $22 Lafayette EAM-15 dynamic hand microphone 2000 ohm impedance can be used any place a dynamic mic is needed. Stripped and tinned leads. It works fine, and looks good also. $25 Generic Hi Z Hand Microphone This hand mic is black in color, and looks like it might have come from a HyGain rig. It has a PTT switch and black coiled cord. $25 DTMF Touch Tone Microphones: KDK DM TT-1 DTMF Touch Tone Microphone This mic has a 12 digit touch tone pad on it, along with a switch to turn the pad on and off. I presently has a 4 pin plug on it, and can be used on most any rig. It works fine, and looks great. $35 CES 655 L "Microdialer" DTMF Microphone You can manual dial a number, or automatically have it stored in the mic, and "speed dial" with this mic. 12 digit touch tone pad on the front, with the microphone part above the pad. This one presently has a 4 pin plug on it, but of course that can be changed. $35 CES 600 L, Universal DTMF microphone This has a normal touch tone pad on the front, with a low impedance microphone. This one has the 8 pin modular plug (like a computer LAN) on it. This mic has not been used, so it is in really great condition. With paper work for $40. Data Signal "Data-Coder 5" touch tone mic This mic has a 12 digit touchtone pad on it, plus a normal low impedance microphone. With 4 pin plug. Like new. $38 Speaker Microphones: MFJ-287 Speaker Microphone This was used on a Kenwood TH-225 HT, but it also fits the TH-21/31/41 series HTs, TH-215, TH-415, as well as others. It has a 3 conductor 3.5 mm plug and a 2 conductor 2.5 mm plug. $15 Kenwood SMC-24 speaker microphone Fits Kenwood TR-2400 HT and others. This one looks fine and works fine. $18 Azden SDX-316 This is the rounder style speaker mic that fits nicely in the palm of your hand. Has 3.5 mm and 2.5 mm plugs for Azden, Icom, some Yaesu, and others. $ 20 Cable for straight key About 3 feet long, with a mono 1/4 inch phone plug on it, as is used with a straight key. $5 As above, but 1/8 inch (3.5 mm) plug. $5 Cable for paddles About 3 feet long, and with a 1/4 inch stereo connector on the end, like used by most rigs. $8 As above, but 1/8 inch (3.5 mm) plug $8 Coax Cable with Type "N" Connectors: This cable is made of RG-8 coax and is about 6 feet long. It has a male type "N" connector on each end. $15 Coax connectors and adapters: Prices are per connector. Several of each are available. These are NOS (have not been used). BNC male for coax cable standard type - $2 crimp on type - $3 Chassis mount BNC female square mount (uses 4 screws) - $3 screw in type - $4 BNC 90 degree - female to male - $3 BNC "T" - two female and one male - $4 Antenna adapter to fit the BNC connector on the HT and provide an SO-239 connector that will permit a PL-259 to be attached. (BNC male to UHF female) $5 UHF Male (PL-259) to BNC female (opposite of above) $5 UHF double female "Barrel connector" (two SO-239 together) $3 UHF "T" connector with two female (SO-239) and one male (PL-259) connection - $5 Prices do not include shipping from Florida. Thanks. 73, Ken, W8EK Ken Simpson E-mail to [email protected] or [email protected] Voice Phone (352) 732-8400 _______________________________________________ Drakelist mailing list [email protected] http://mailman.zerobeat.net/mailman/listinfo/drakelist
