Drake items for sale:
Drake TV-3300-LP Low Pass Filter This is a modern low pass filter to go between your transmitter and antenna, and has been optimized to have more attenuation in the 40 MHz region, where many TVs have their IF. It is good for 1000 Watts "average" according to the manual, and has over 80 db attenuation at 41 MHz. This one looks great, and includes the paper work. $30 Case for Drake TR-33 C This is the black case that fits the Drake TR-33 C, and has cutouts in the back for antenna, power, etc. It includes the shoulder strap, and is in good shape. $12 Case for Drake TR-22 As above, but for the TR-22. No shoulder strap. $10 3 pin mic plug for TR-22 This is the small 3 pin mic plug that fits the Drake TR-22 mic jack. It is much smaller than most of the mic connectors. I thought these were completely gone, but one appeared from a silent key. This one has been used, but should still be usable some more. $10 Communications Speaker This 4 inch square speaker is optimized for communications frequencies (300 to 3000 Hz). It is in a black enclosure, and is an 8 ohm speaker. It has a cord with a 1/8 inch (3.5 mm) mono plug on the end. This one works fine and looks OK also. $15 Microphones: All of these microphones have been tested and work well. Shure 401 B, Low Z Hand Microphone This mic has characteristics similar the the Shure 444 Desk Mic, but this one is a hand mic. It is a controlled magnetic mic, with frequency response tailored for voice communications. It has a rugged case, and a heavy duty coiled cord. 4 pin connector. With paper work for $40. Shure 104 C, Low Z hand Microphone This is a very heavy duty Shure mic. It appears to be new, with stripped and tinned ends that have never been on a connector. It is in its original box, with the original instruction manual. $30 Generic Hand Microphone This is a low impedance hand microphone, black in color. With 4 pin connector. $25 With no connector. $22 Lafayette EAM-15 dynamic hand microphone 2000 ohm impedance can be used any place a dynamic mic is needed. Stripped and tinned leads. It works fine, and looks good also. $25 Generic Hi Z Hand Microphone This hand mic is black in color, and looks like it might have come from a HyGain rig. It has a PTT switch and black coiled cord. $25 Johnson Hi Z Hand Microphone This high impedance hand mic is a gray color, with the Johnson logo with the Viking on it. It has a PTT switch and coiled cord, and produces a nice pattern on the scope. It looks extremely good also. Not a scratch on it, and it even shines! $30 DTMF Touch Tone Microphones: Icom HM-23 DTMF Touch Tone Microphone With round 8 pin connector, Up-Down, switches, and 16 digit touch tone pad. This was originally used on the IC-27, 28, 37, 47, etc, that requires a long nut for the recessed connector. Of course it can also be used on rigs that do not have the recessed connector. It works fine and looks close to new. $45 Johnson 250-0761-010 / CES 655 L DTMF Mic It has a 12 digit pad on the front, and is a rugged mic. Presently with 4 pin plug. Looks to be unused. $40 KDK DM TT-1 DTMF Touch Tone Mic This mic has a 12 digit touch tone pad on it, with a switch to turn the pad on and off. With 4 pin plug. It works fine, and looks great. $35 Data Signal "Data-Coder 5" Touch Tone Mic This mic has a 12 digit touch tone pad on it, plus a normal low impedance microphone. With 4 pin plug. Like new. $38 CES 610 L DTMF Touch Tone Mic Can manually dial a number, or automatically store it in the mic, and "speed dial". 12 digit touch tone pad on the front, with the microphone part above the pad. With an 8 pin modular plug (like a computer LAN) on it, which can be changed. Looks to be new. $40 Speaker Microphones: MFJ-287 Speaker Microphone This was used on a Kenwood TH-225 HT, but it also fits the TH-21/31/41 series HTs, TH-215, TH-415, as well as others. It has a 3 conductor 3.5 mm plug and a 2 conductor 2.5 mm plug. $15 Kenwood SMC-24 speaker microphone Fits Kenwood TR-2400 HT and others. This one looks fine and works fine. $18 Azden SDX-316 This is the rounder style speaker mic that fits nicely in the palm of your hand. Has 3.5 mm and 2.5 mm plugs for Azden, Icom, some Yaesu, and others. $ 20 Cable for straight key About 3 feet long, with a mono 1/4 inch phone plug on it, as is used with a straight key. $5 As above, but 1/8 inch (3.5 mm) plug. $5 Cable for paddles About 3 feet long, and with a 1/4 inch stereo connector on the end, like used by most rigs. $8 As above, but 1/8 inch (3.5 mm) plug $8 Coax Cable with Type "N" Connectors: This cable is made of RG-8 coax and is about 6 feet long. It has a male type "N" connector on each end. $15 Coax connectors and adapters: Prices are per connector. Several of each are available. These are NOS (have not been used). BNC male for coax cable standard type - $2 crimp on type - $3 Chassis mount BNC female square mount (uses 4 screws) - $3 screw in type - $4 BNC 90 degree - female to male - $3 BNC "T" - two female and one male - $4 Antenna adapter to fit the BNC connector on the HT and provide an SO-239 connector that will permit a PL-259 to be attached. (BNC male to UHF female) $5 UHF Male (PL-259) to BNC female (opposite of above) $5 UHF double female "Barrel connector" (two SO-239 together) $3 UHF "T" connector with two female (SO-239) and one male (PL-259) connection - $5 Prices do not include shipping from Florida. Thanks. 73, Ken, W8EK Ken Simpson E-mail to [email protected] or [email protected] Voice Phone (352) 732-8400 __________ Information from ESET NOD32 Antivirus, version of virus signature database 5191 (20100611) __________ The message was checked by ESET NOD32 Antivirus. http://www.eset.com _______________________________________________ Drakelist mailing list [email protected] http://mailman.zerobeat.net/mailman/listinfo/drakelist
