Fellow Drake Enthusiasts,
Yes, the subject line is strange but trust me, it does relate to Drake. I'm in the process of finalizing a project and will be describing it in some open source publication or website. It relates to the power supplies used with the Drake L4, L4B, and L7 linear amplifiers. As part of this project, I need to saw the phenolic boards used in the supplies as well as sawing fiberglass-epoxy board, 1/8 inch thick, that is similar to high quality printed circuit boards, only without any foil on either side. My question is, can I use my table saw typically used to cut wood, to cut the phenolic and the fiberglass-epoxy board? I'm not sure if the material is so hard that it would cause heating and binding, or whether it would rapidly dull the blade. Your expert advice would be greatly appreciated. Enjoy those Drakes. 73, Evan =
_______________________________________________ Drakelist mailing list [email protected] http://mailman.zerobeat.net/mailman/listinfo/drakelist
