Is there a new replacement drive for the L4B and L7 verniers that can be
purchased?

Dennis AE6C

On Thu, Jan 13, 2011 at 2:05 PM, K9sqg <[email protected]> wrote:

> Dino,
>
> This is normal operation for a vernier drive that has either sat for an
> extended period of time unused or, in less frequent cases, one that has had
> a lot of use.  There are ways of cleaning, relubing, and then repositioning
> things so the drive has "renewed bite" so to speak.  However, for all it
> takes to do this in terms of time and effort, one can consider just
> replacing the drive itself.  It is a matter of personal preference.  Good
> luck with your decision.
>
> 73,
>
> Evan
>
>
>
>
> -----Original Message-----
> From: Dino Papas <[email protected]>
> To: Mail List - Drake Gear Drake Gear <[email protected]>
> Sent: Thu, Jan 13, 2011 3:59 pm
> Subject: [Drakelist] L-4B Plate Tuning Cap Question
>
> Well, today in anticipation of rebuilding my L-4BPS I decided to finally 
> install
> the Harbach soft-start module in the amp (hey, its only been sitting in the
> project queue for a few years....no sense in rushing).
>
> While I had it open did the normal maintenance stuff, lubed the fan etc.  I've
> had a problem now for a couple of months with the plate tuning cap turning
> action.  Somewhere between the 80m and 40m sections the turning action slows
> down to a standstill and you'd have to spin the knob several times to get it 
> to
> move VERY slowly thru its rotation.
>
> With the amp opened up I found that a little bit of pressure applied either 
> as a
> push or pull would get the cap to rotate at almost normal speed throughout its
> rotation.  Not wanting to screw something up I decided to leave it alone and
> check with the group.  It may just be that after 32 years the rotation 
> mechanism
> is just wearing out.
>
> Anyone else experience this?  If so any fixes?
>
> Thanks in advance!
>
> Dino KL0S
>
> BTW, the Harbach module works great....the power supply board is built and 
> ready
> to install but think I've done enough for today!
> _______________________________________________
> Drakelist mailing 
> [email protected]http://mailman.zerobeat.net/mailman/listinfo/drakelist
>
>
> _______________________________________________
> Drakelist mailing list
> [email protected]
> http://mailman.zerobeat.net/mailman/listinfo/drakelist
>
>
_______________________________________________
Drakelist mailing list
[email protected]
http://mailman.zerobeat.net/mailman/listinfo/drakelist

Reply via email to