Tried cc of message to list, didn't get in my mail, so trying again. Purchas order and Company address? Not unless it's a very recent change. I checked their site, ORDER DIRECT 800-311-3374, along with some product information. Purchase order is one option, along with Mastercard, Visa, more. I've been ordering for a long time, go through a gallon of Kroil a year, on average, excellent file cleaner, btw, and keeps oilstones from clogging much longer. Silikroil much better for cement shovel pre-treat, and firearms. Microil close to sperm oil for instruments, sewing machines, fishing rells, clocks,( VFO shafts???)
clean chassis with very mild detergent or similar, to get below any oil film or similar, after drying, I used q-tips, short and long, and Kroil, set up next to coffee pot, so while coffee brewing, and at breaks, dip q-tip in the kroil and apply to spotting rust. After a couple of applications, a brownish film will appear on the q tip with gentle rubbing as the rust begins to disolve. Rubbing too hard will dislodge rust specs and scratch the copper finish. Be patient. Take before and after pictures, for your own use, at least. I suspect, without proof, the rust spotting starts as microscopic pinholes, dampness, and if available any salt in the air (oceans near?) I further suspect dissimilar metal electrolysis, perhaps grounding or similar minor contributor? All the above likely. After cleanup, something would be helpful to seal and protect the surface, oil would be a dust magnet, perhaps some electronics sealer coating? Suggestions in order. I am very pleased with the results, but don't think it's a replacement for a day job or similar. LOL. Also for sale at midway, and Brownells: shooters use it now. While you're at Kano, check out the Kreen if you vehicle has years and miles on it. Pint in clean oil, tank of hi-test and new filters, pint in oil and pint in gas. 3k on oil and change hot. Cleans out carbon and sludge, plus deposits in fuel system. Won't replace a valve job, but increased milage will pay for use, and longer life. I've been using Kroil since 1984, introduced during GE turbine crew on overhauls. a drop on a rusted bolt nutand watch close. Rusted 20 year exhaust manifold studs a two or three time application avoids busted studs if you don't overtorque too early. regards, kendwell AB1JZ Millwright _____________________________________________________________ Netscape. Just the Net You Need. _______________________________________________ Drakelist mailing list [email protected] http://mailman.zerobeat.net/mailman/listinfo/drakelist
