There should be ten bearings, 1/8" diameter steel, plus one more at the
back end of the lead screw. If you can't get all ten in, loosen the
adjuster screw at the rear of the lead screw.
--
73, Garey - K4OAH
St Charles, IL
Drake 2-B, 2-C/2-NT, 4-A, 4-B, C-Line
and TR-4/C Service Supplement CDs
<www.k4oah.com>
Ron Ries wrote:
Steve, I read that you rebuilt the ball bearing on the PTO shaft on the R-4B
that you recently acquired. I am in the process of restoring one also that I
bought from Bob and noticed that there appears to be one less ball in the race
than the race will accommodate. Is this what you found also? Otherwise, someone
rebuilt the bearing and apparently 'dropped a ball!'
Thanks!
Ron
_______________________________________________
Drakelist mailing list
[email protected]
http://mailman.zerobeat.net/mailman/listinfo/drakelist
