It's interesting that the pin 6 resistance to ground is so low since it passes
through a 82K resistor. Do the values change if you remove V8? I sense a tube
short.
73,
Bob WW3QB
________________________________
Well, my nose detected burnt smell in vicinity of T4. R61, a 150ohm 1/2
resistor in the 250 volt line to V8's plate is burnt to a crisp, resistance is
zero. But why? Resistance to ground on V8 pin 5 is 15k per spec. But pin 6
screen grid resistance to ground it 15k, vs 90k spec.
Any advice? 73, Curt KB5JO
_______________________________________________
Drakelist mailing list
[email protected]
http://mailman.zerobeat.net/mailman/listinfo/drakelist
_______________________________________________
Drakelist mailing list
[email protected]
http://mailman.zerobeat.net/mailman/listinfo/drakelist
