Hi again,

On Friday, 6 April 2018 16:45:16 EEST Laurent Pinchart wrote:
> On Friday, 6 April 2018 16:08:10 EEST Jacopo Mondi wrote:
> > Enable DU for Renesas R-Car V3M Eagle board.
> > 
> > Signed-off-by: Jacopo Mondi <jacopo+rene...@jmondi.org>
> > ---
> > 
> >  arch/arm64/boot/dts/renesas/r8a77970-eagle.dts | 11 +++++++++++
> >  1 file changed, 11 insertions(+)
> > 
> > diff --git a/arch/arm64/boot/dts/renesas/r8a77970-eagle.dts
> > b/arch/arm64/boot/dts/renesas/r8a77970-eagle.dts index 3c5f598..144b847
> > 100644
> > --- a/arch/arm64/boot/dts/renesas/r8a77970-eagle.dts
> > +++ b/arch/arm64/boot/dts/renesas/r8a77970-eagle.dts
> > @@ -76,6 +76,11 @@
> > 
> >             function = "i2c0";
> >     
> >     };
> > 
> > +   du_pins: du {
> > +           groups = "du_rgb666", "du_sync", "du_oddf", "du_clk_out";
> > +           function = "du";
> > +   };
> 
> As far as I can tell the DU parallel output isn't used on the Eagle board,
> but is used on the Eagle expansion board. I would move this to patch 7/7 in
> this series.

My bad, patch 7/7 describes the on-board HDMI encoder, not the one on the 
expansion board. I would thus drop pinmux completely for now until we add 
support for the expansion board.

> >     scif0_pins: scif0 {
> >     
> >             groups = "scif0_data";
> >             function = "scif0";
> > 
> > @@ -93,3 +98,9 @@
> > 
> >     status = "okay";
> >  
> >  };
> > 
> > +
> > +&du {
> > +   pinctrl-0 = <&du_pins>;
> > +   pinctrl-names = "default";
> 
> These two properties should be moved to patch 7/7 too.

So this should be removed.

> > +   status = "okay";
> > +};
> 
> There's little use for enabling the DU in DT if you have no output port
> described. I'd move this to patch 6/7.

And I'd merge the status attribute and patches 6/7 and 7/7 all together.

-- 
Regards,

Laurent Pinchart



_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel

Reply via email to